![]() So while Seagate led the way, just about everyone saw marked improvements.īackblaze describes the notable improvement of AFR across the board as “a group effort.” On one hand, older drives as a group - which consists of 4TB, 6TB, 8TB, and 10TB capacity drives - improved in 2020 by going from 1.35% AFR in the year prior to 0.96% AFR. An improvement compared to the year prior, the AFR for all of the models included in the 2020 report was 0.93% which was less than half the AFR for 2019 which stood at 1.89%. “While each drive model has only been installed for about two months, they are off to a great start.”Ĭlose runners up to Seagate were two HGST 4TB drives (models HMS5C4040ALE640 and HMS5C4040BLE640) with 0.27% AFR, followed by the 8TB drive (model HUH728080ALE600) at 0.29% AFR, and the 12TB drive (model HUH721212ALE600) at 0.31% AFR. “The new Toshiba 14TB drive (model: MG07ACA14TA) and the new Toshiba 16TB (model: MG08ACA16TEY) were introduced to our data centers in 2020 and they are putting up zeros, as in zero failures,” the company writes. While there are other drives that may show a lower failure rate, such as Toshiba, the number of drives tested was too low or the amount of time they have been active was too short to assume the AFR would be consistent over a larger number of drives. Somewhat unexpectedly, for drive models with over 250,000 drive days over the course of 2020, the Seagate 6TB drive (model ST6000DX000) led the way with a 0.23% annualized failure rate (AFR) despite it being the oldest model of all the drives listed on the table.ĪFR refers to the estimated probability of a hard drive failure during a full year of use. After all exclusions, the company was left with 162,299 hard drives that it used to compile the data below. The company explains that the reason for excluding boot drives from gathering this data is simply because their function is greatly different from that of a typical hard drive, however, if any useful data is gathered in the future, Backblaze intends to publish it. For this report, the company omitted 231 hard drives in its research as they were used for testing or if the company did not have at least 60 drives of a certain model. Out of those, 3,000 were boot drives and the rest of the 162,530 were hard drives. Backblaze, one of the leading cloud storage and backup companies, has just released information on its hard drive failure rates throughout 2020, revealing which models fared better than others.Īs noted by DPReview, Backblaze reports that 39,792 hard drives were added to its assortment in 2020 and by the end of the year, the number of drives under its management reached a total of 165,530.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |